Brookfield CT3 Texture Analyzer Manuale Utente Scaricare il pdf (Pagina 51)

Brookeld Engineering Labs., Inc. Page 51 Manual No. M08-372-C0113

Appendix B - Troubleshooting

If no power to the instrument:

Check:

• Userreplaceablefuses:two(2)fuses,4amp,5x20mm,time-laglocatedbehindremovable

redcolorpaneljustaboveswitch.

• Fuseslocatedwithinpowerentrymoduleontherearoftheinstrument.

• Ifthefusesblowcontinually,seriousdamagetotheinstrumentcouldresult.Contactrepair

services immediately.

Probe won’t attach:

• Checkthethreadonprobeandprobeshaft-removeanydirt.

Rotary Base table won’t move:

• Ensurethelockingknobisloose.

• Ensuretheneadjustnutisloose.

Rotary Base table will not travel to the lowest position:

• Loosentheneadjustnutandrotatebasetable.

• LocatethetableincenterofT-slot.

Instrument is unsteady:

• Ensurethatthebenchtopisstable.

• AdjusttheCT3feet.

Probe doesn’t move when start is pressed:

• Ensuretheemergencystopbuttonisnotpressedin(rotateclockwise).

• EnsurethetestmodeisnotinStaticLoad.

• Ensuretheprobeisnotincontactwithsample(orbasetable).

Display shows “REMOTE OPERATION”

• ThiswillalwaysshowwhenthecomputerinterfacecableisconnectedtotheCT3.Touse

the CT3 without the computer program, the serial cable must be disconnected.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56

Nessun commento

Brookfield CT3 Texture Analyzer Manuale Utente Pagina 51